Förster-Technik TAP5-VS2-50 - Version; Setup; Software; Remote Maintenance

Faults and warnings 113
9.5.7 Version
In the Version menu, you can check version numbers. The following units have a version num-
ber:
• Feeder
• Processor
•ID chip
• Terminal
• Identifications at existing feeding stations.
• Peripheral device
Check the version as follows:
1. Navigate via > Diagnostics to switch to the Version sub-menu.
2. Then use Go to the desired sub-menu and read the version number.
9.5.8 Setup
In this menu you can only view the settings. To make changes, you must open the setup menu
(see 5. "Setup" - 59 and following pages)
You check the setup settings as follows:
1. Navigate via > Diagnostics to switch to the Setup sub-menu.
2. Go to the desired sub-menu and check the settings.
9.5.9 Software
This menu is only intended for the manufacturer’s development department.
9.5.10 Remote maintenance
During remote maintenance, the automatic feeder is operated via the CalfCloud.
1. Navigate via > Diagnostics to switch to the Remote maintenance sub-menu.
2. In start?, you permit remote maintenance of the automatic feeder.
3. In end?, you break off remote maintenance of the automatic feeder.
4. In Status, you can see the current status of the connection to the cloud. The possible sta-
tuses are online, offline or reconnecting.
5. In Service-ID you can view the unique service identification number of the automatic feeder.
Note: Remote maintenance starts when the service ID is entered into the cloud. The service
ID is valid until 23:59:59 hours.