Commissioning 33
3.11 Switching on the automatic feeder
Insert the mains plug and switch the automatic feeder on again using the Main switch .
Use the hand terminal to control the automatic feeder.
Note: After the hand terminal has been switched on, the version of the hand terminal's program
first briefly appears in the display, before the automatic feeder carries out a test routine. Do not
press any buttons on the control panel during these initial routines.
3.12 Setting the date/time
When the start routine is complete, the message Perform basic settings appears.
1. Set the current date and confirm it with .
2. Set the current time and confirm it with .
3.13 Filling the boiler
1. In the display, you will see the fault message Boiler not filled. Press .
2. Confirm Fill boiler? by choosing .
The boiler will be filled with water.
3.14 New installation
During the initial startup and restart process for the automatic feeder, the program (software)
must be completely reconfigured (reset). This will remove superfluous data as well as outdated
or incorrect settings from the memory.
Note: Choosing Reinstallation deletes the Animal data (group membership, barn transfer
date, feeding days, consumption sums), the transmitter numbers are set to zero and the de-
vice data and the feeding plans are overwritten with default values.
Reconfigure all menus as follows:
1. Navigate via > Device data to the Reinstallation sub-menu.
2. Confirm Everything by choosing .
3. Confirm Reinstall everything? by choosing .
4. Confirm the security prompt Do you really want to restore the data to factory settings?
by choosing .
5. Confirm Reinstallation completed! by choosing .
All data has been reset to factory settings.
Note: The settings in the feeder setup are not changed by Reinstallation.
To Next Page
Loading...