54 Programming and control
This is how to perform data restoration:
1. Navigate via > Device data > Data backup to the SD card sub-menu.
2. Confirm Restore? by choosing to perform a backup.
2.1. If required, enter the date from which you would like to restore the data into the Date
menu, and confirm this with .
3. In the Date menu, you can see when the last data backup was performed.
4. Close the rubber cover.
4.6.7.3 Cloud
In this menu, you can back up data to the CalfCloud.
Perform a backup as follows:
1. Navigate via > Device data > Data backup to go to the Cloud sub-menu.
2. Confirm save? by choosing .
A progress bar informs you about the current status of the data backup being carried out.
This is how to perform data restoration:
1. Navigate via > Device data > Data backup to go to the Cloud sub-menu.
2. Confirm Restore? by choosing to perform a backup.
2.1. If required, enter the date from which you would like to restore the data into the Date
menu, and confirm this with .
3. In the Date menu, you can see when the last data backup was performed.
4.6.8 Cloud
This menu allows you to perform the relevant settings for the cloud.
1. Navigate via > Device data to go to the Cloud sub-menu.
2. In Finish? you break off the connection to the cloud and therefore stop data transfer.
3. In start?, press . You then create the connection between the cloud and the automatic
feeder.
You will see the message You hereby accept the data protection provisions listed on
www.calf-cloud.com!. Press .
4. In Status, you can see the current status of the connection to the cloud. The possible sta-
tuses are online, offline or reconnecting.
5. In Auth. token you can see the authentication key for the automatic feeder.
Note: This token allows you to add the automatic feeder to the cloud data.
6. In last error you can view the following error displays:
To Next Page
Loading...