Programming and control 53
Restoring data
This is how to perform data restoration:
1. Navigate via > Device data > Data backup to the Internal (automatic feeder) sub-
menu.
2. Confirm Restore? by choosing .
3. Confirm the security prompt Restore last backup? by choosing .
A progress bar informs you about the current status of the data restoration being carried out.
Checking the available data backup
Check the data backup as follows:
1. Navigate via > Device data > Data backup to the Internal (automatic feeder) sub-
menu.
2. In the last backup menu, you can view the time and date when the last backup was per-
formed.
4.6.7.2 External data backup using an SD card
During each backup, a folder with the date of the backup is created on the SD card. If data res-
toration is required, a date stored on the SD card can be entered and selected using the num-
ber field. The date of the last backup is always shown on the display.
When the feeder is delivered, by default an SD card is fitted in the slot on the hand terminal.
The SD card should remain in the hand terminal at all times.
SD card and hand terminal
Proceed as follows to perform a data backup using an SD card:
1. Open the rubber cover on the right side of your hand terminal.
2. Insert the SD card into its slot.
3. Navigate via > Device data > Data backup to the SD card sub-menu.
4. Confirm save? by choosing .
A progress bar informs you about the current status of the data backup being carried out.
To Next Page
Loading...