88 Shutdown and recommissioning
10. Connect the Ethernet cable.
11. Remove the locks on the antenna connections and connect them to the antennas.
12. Plug the power plug into the power outlet.
13. Switch the automatic feeder on using the Main switch .
Fault, Boiler not filled will appear in the display of the hand terminal.
14. Press .
15. Confirm Fill boiler? by choosing .
The boiler is automatically filled with water.
16. Navigate via > Device data to the Time or Date.sub-menu.
16.1. In the Time menu, you enter the time of day using the number keys
16.2. In the Date menu, you enter the time of day using the number keys.
16.3. In the Format menu, choose , the desired format for the date.
17. Start the maximum number of cleaning programs (see Cleaning chapter in the operating
manual for the automatic feeder).
Clean the hoses and the powder container.
By doing this, you prevent germs that enter the automatic feeder from multiplying and infect-
ing your calves.
18. Fill the powder container with milk substitute (MP). Use only milk substitute that is suitable
for feeding calves.
NOTICE!
► Make sure that no paper or other foreign bodies enter the powder container. This could dam-
age the dosing mechanism or impair dosing accuracy.
19. Calibrate all feed components (see 3.23 "Calibrating feed components" - 35).
20. Check the setup settings (see 5. "Setup" - 59).
8.2.2 Recommissioning after processor card replacement
After a shutdown, for example after replacing the processor board, you must set up the device
data again.
Proceed as follows:
1. Switch on the automatic feeder.
2. Confirm the message first startup press enter to start installation by choosing .
3. The message restore last backup? will appear if there is a valid backup of the animal and
device data in the automatic feeder. Confirm the message with .
To Next Page
Loading...