Commissioning 29
1 Socket
2 Ethernet cable of automatic feeder
8. Place the unattached seal and the screw connection around the unattached Ethernet cable
and connect the end to the socket.
1 Screw connection
2 Ethernet cable
3 Screw connection
4Seal
9. Insert the cable connector into the cylinder and tighten the cylinder and seals.
10. Push the cylinder into the bracket into the housing of the automatic feeder.
3.7 Installing the safety grid for the powder hopper attachment
Install the safety grid as follows:
1. Switch the automatic feeder off.
2. Remove the bag with the small parts and hoses as well as the operating manual from the
powder hopper.
3. Insert the safety grid for the powder hopper attachment.
4. Screw in the three self-tapping screws into the holes provided.
To Next Page
Loading...