Programming and control 55
6.1. none. There are no errors present.
6.2. no eth. cable. No Ethernet cable is plugged in.
6.3. no Internet. There is no Internet connection available.
6.4. connect.error. There is a connection error to the server.
7. File Transfer is only for the manufacturer.
4.6.9 New installation
The program (software) must be completely reinstalled (reset) when commissioning or recom-
missioning the automatic feeder. This will remove superfluous data as well as outdated or incor-
rect settings from the memory.
Note: New installation will result in the deletion of the animal data. The transmitter numbers
will be set to zero and the Device data will be overwritten with default values.
Animal data is, for example, group membership, barn transfer date, feeding days, consumption
totals.
Device data includes portion settings, for example.
4.6.9.1 Only reinstall device data, plans, animal data or transmitter numbers
Proceed as follows to reinstall device data, plans, animal data or transmitter numbers:
1. Navigate via > Device data to the Reinstallation sub-menu.
2. Confirm Device data by choosing .
3. Confirm Reinstall device data? by choosing .
4. Confirm the security prompt Do you really want to restore the data to factory settings?
by choosing .
The message Reinstallation completed! will appear
5. Confirm Reinstallation completed! by choosing .
You are back in the Reinstallation menu.
6. Perform steps 2 to 5 in the same manner for plans, animal data or transmitters.
4.6.9.2 Reinstalling everything
You can also reconfigure all menus instead of individual menus.
Reconfigure all menus as follows:
1. Navigate via > Device data to the Reinstallation sub-menu.
2. Confirm Everything by choosing .
3. Confirm Reinstall everything? by choosing .
4. Confirm the security prompt Do you really want to restore the data to factory settings?
by choosing .
To Next Page
Loading...