68 Setup
5.9 Stations
Activate the feed or concentrate station and define the additional equipment for these stations
or any additional equipment in the Stations menu.
5.9.1 Feed
You set the feeding box as follows:
1. In the setup menu, choose the Stations > Feed > Internal option.
2. Choose intern 1 or intern 2.
3. In the Allocation menu, select the feeding box to be allocated to the internal control system.
4. Confirm your entry with .
5.10 Terminal
5.10.1 Address
The hand terminal is integrated into the CAN bus system of the automatic feeder. That is why
is needs its own address. Address 1 is set by default.
Note: In a CAN bus system, each address may only be assigned once.
You set the address as follows:
1. In the setup menu, choose the Terminal option.
2. In Address, select [1].
3. Confirm your entry with .
5.10.2 Contrast
You set the contrast as follows:
1. In the setup menu, choose the Terminal option.
2. In Contrast, enter the desired value. The default value is 60%
3. Confirm your entry with .
5.10.3 Sleep mode
If no key has been pressed on the hand terminal for a fairly long period of time, it will switch to
sleep mode. If the hand terminal is in sleep mode, the Förster-Technik logo will appear in the
display.
You set sleep mode as follows:
1. In the setup menu, choose the Terminal option.
2. In Sleep mode, enter the desired value. The default value is 10 minutes. To deactivate sleep
mode, set [0] minutes.
To Next Page
Loading...