70 Setup
4. In Finish? you break off the connection to the cloud and therefore stop data transfer.
5. In Status, you can see the current status of the connection to the cloud. The possible sta-
tuses are online, offline or reconnecting.
6. In Auth. token you can see the authentication key for the automatic feeder.
Note: This token allows you to add the automatic feeder to the cloud data.
5.11.4 Gateway
Here you can configure all relevant parameters of the Förster gateway (optional).
• (M) MAC address: You can see the MAC address of your gateway here. Your gateway is
uniquely identified via its MAC address. This address cannot be changed.
• (IP) IP address: You can see the IP address of your gateway here and, if need be, change
it. You will need this value to register your feeder at the CalfManagerWIN or in connection
with the communication module.
• (SN) Subnet mask: You can see the subnet mask of your gateway here and, if need be,
change it.
• IP assignment: If the value here is automatically set, then your gateway will try to get its
IP address from a DHCP server in your network. If you select manual here, then you will
have to set the IP address of your gateway yourself.
• DHCP status (only in connection with the automatic assignment of IP addresses): This line
gives you information about the internal status when getting the automatically assigned IP
address. There are five statuses that can occur: OK, waiting, off, on and unknown (=n/a).
• Factory settings: If you call up this item and confirm the security query which then appears,
the values of your gateway for the IP address, the subnet mask and the manual or automatic
procurement of the IP address will be reset back to the factory settings.
5.11.5 MultiReader
Here you can call up information about the connected MultiReader calf identification system.
• Version shows the current version of the MultiReader identification system.
• If in the Update menu you press you can update the MultiReader identification system.
Note: To update the MultiReader identification system, you may have to first update the au-
tomatic feeder.
5.11.6 Restart
Here you can restart the automatic feeder.
To Next Page
Loading...