58 Programming and control
4.3. If there is a version available for the peripheral devices, the message Peripherals
update available... will appear Press <Enter> to download and install the new
firmware!. Confirm with , to start the download.
4.4. Once the download has been completed, the message Download completed will
appear. Press <Enter> to start installation. Confirm with , to start the update.
4.7.3 Software update via internal (automatic)
The expert menu Device data > Software Update > Internal (automatic) is intended for use
by the manufacturer. By this means a software update can be performed via a micro SD card in
the control box of the automatic feeder and the FTP Manager.
4.8 Reinstallation
In the event of a fault in the course of reinstallation, delete all the data saved on the automatic
feeder.
All the device data, plans and medicine formulations will be reset to factory settings and all an-
imal data and transmitters deleted.
Perform a reinstallation as follows:
1. Switch the automatic feeder off.
2. Press + and keep the key depressed whilst you switch the automatic feeder on and
wait until the message Reinstallation appears in the display.
3. Confirm with , to continue. The automatic feeder will restart and all the data will be de-
leted.
4. Set the desired language and confirm it with .
5. Set the current date and confirm it with .
6. Set the current time and confirm it with .
The automatic feeder will switch to the Setup menu.
7. Read the ID chip.
8. Check the setup settings as follows:
All the device data, plans and medicine formulations were reset to factory settings and all
animal data and transmitters were deleted.
9. Perform a data restoration (see 4.6.7 "Backing up and restoring data" - 52) and set up the
automatic feeder.
To Next Page
Loading...