Setup 63
Note: When connecting more than one automatic feeder, be sure that each number is only as-
signed once.
You select the feeder number as follows:
1. In the setup menu, choose the Machine option.
2. In Number, you select a number.
3. Confirm your entry with .
5.4.3 Automatic feeder address
For unique identification, every participant of the CAN bus system needs an address.
You select the feeder address as follows:
1. In the setup menu, choose the Machine option.
2. In Address, you select an address.
3. Confirm your entry with .
Note: If you select an address that has already been assigned, the message Address already
assigned! will appear in the display.
5.4.4 Feeder operating modes
Please leave the factory set value SA (= StandAlone) unchanged.
5.4.5 Base size
The set value determines:
• The set quantity for calibrating the Water Boiler.
• The standard portion size.
You define the size as follows:
1. In the setup menu, choose the Machine option.
2. In Base size, enter 500.
3. Confirm your entry with .
Address ranges for CAN participants
1-10 => hand terminal
11-20 => automatic feeder
21-30 => Forefoot weighing machine
41-50 => IFS feed single
51-60 => IFS-C
61-70 => IFS feed 4-fold
71-79 => CalfRail
To Next Page
Loading...