Setup 59
5. Setup
The program menus in the setup menu contain basic settings, e.g. for the equipment of the au-
tomatic feeder. Check to ensure that the settings are correct.
You open the setup menu as follows:
1. Press and keep this key pressed when you switch on the feeder.
After a short time, the Setup menu will appear in the display.
2. If you want to change settings, go to the relevant menu option and make the changes.
3. Confirm the changes with .
4. To exit setup, repeatedly press , until the message End setup? appears. Confirm with
.
Note: Also observe the operating manual for the automatic feeder.
To Next Page
Loading...