56 Programming and control
The message Reinstallation completed! will appear
5. Confirm Reinstallation completed! by choosing .
You are back in the Reinstallation menu.
Note: The settings in the feeder setup are not changed by Reinstallation.
4.6.9.3 In the event of a fault
If the data are corrupted and the automatic feeder no longer boots up or no longer boots up cor-
rectly, for instance when the feeder continually reboots, there is a facility to recreate the avail-
able data.
Reconfigure the automatic feeder as follows:
1. Press + and keep these keys pressed when you switch on the feeder.
When the boot loader is reset, the database, following the display instructions is deleted.
The data from the FRAM are then transferred back.
4.7 Software updates
To update the application program, depending on the equipment, you have a choice available
between an SD card, FTP Manager or CalfCloud.
The options available for your equipment can be seen in the dealer area of Förster-Technik's
web site www.foerster-technik.de.
4.7.1 Software update via SD card
The SD card update is performed using the SD card in the hand terminal, and includes updating
of all CAN participants. If an update of the ActivityBox and the MultiReader detector is required
this must be performed separately.
Proceed as follows to perform a data update using an SD card:
1. Insert an empty SD card into the slot in the hand terminal.
2. Navigate via > Device data > Data backup to the SD card sub-menu.
3. Confirm save? by choosing .
A progress bar informs you about the current status of the data backup being carried out.
4. Remove the SD card.
Note: The data backup that is performed serves as a backup in the event of problems.
5. Switch the automatic feeder off.
6. Press and keep this key pressed when you switch on the feeder.
After a short time, the Setup menu will appear in the display.
7. Insert the SD card carrying the update data into the slot in the hand terminal.
To Next Page
Loading...