32 Commissioning
5. Connect the sealing cap to the elbow coupling and secure this once again to the cleaning
agent lance.
6. Connect the cable of the cleaning agent lance to the cable tail (5th or 6th socket counting
from the top) on the left hand side of the automatic feeder.
7. Insert the cleaning agent lance through the cover of the cleaning agent container and secure
it.
Note: Small breather holes in the cover prevent the creation of a partial vacuum which would
distort the cleaning agent container. In this respect comply with the manufacturer's specifi-
cations and the national regulations.
8. Position the cleaning agent container in the place provided for it.
Make sure that the suction tube is inserted cleanly and properly in the cleaning agent con-
tainer.
DANGER!
Danger of death if the cleaning agents are switched over!
This can result in the release of chlorine gas which is highly explosive and can cause severe
chemical burns.
► Make absolutely sure that the suction hoses to the cleaning agent pumps are inserted in the
correct containers. Additionally observe the specifications in the respective installation in-
structions.
To Next Page
Loading...