Programming and control 51
Here is how you define which parameters are displayed in the two columns of the animal
list:
1. Navigate via > Device data to the Animal list sub-menu.
2. In Column 1 or Column 2, select by choosing which parameter is displayed in the
respective column.
You call up an animal list as follows:
1. Navigate via to the Animal list sub-menu.
2. In the top line, from left to right, you can check the following:
• The number of the calf you have selected in the list, counting from the top (1).
• How many calves are registered (2).
• The two parameters you have chosen (3 & 4).
3. You can view the following in the subsequent lines, from left to right:
• The animal number (1).
• The plan tendency (2).
• The group to which the calf concerned has been assigned (3).
• The last feeding box visited (4).
• Parameter 1. The current value (today) is in the column on the left (5). Yesterday's value
is in the column on the right (6).
Note: The parameter for feed consumption is simply today's value or yesterday’s value
in liters to two decimal places. The list can be sorted by the parameter feed consumption
today in %.
• Parameter 2. The current value (today) is in the column on the left (7). Yesterday's value
is in the column on the right (8).
Note: If there is a check mark instead of a number,
then the value is 100%. A check mark followed by a
plus indicates a value greater than 100% (only for
drinking speed and visits).
To Next Page
Loading...