Fortinet FortiMail-100 - Removing a Fortimail Board

FortiMail-5001A hardware installation Removing a FortiMail board
FortiMail™ Secure Messaging PlatformVersion 4.0 Patch 1Install Guide
Revision 2 59
http://docs.fortinet.com/ • Feedback
If the board has not been inserted properly the IPM LED changes to solid blue and all
other LEDS turn off. If this occurs, open the handles, slide the board part way out, and
repeat the insertion process.
10 Once the board is inserted correctly, fully tighten the retention screws to lock the
FortiMail board into position in the chassis slot.
Removing a FortiMail board
The following procedure describes how to correctly use the FortiMail mounting
components described in “FortiMail mounting components” on page 55 to remove a
FortiMail board from an ATCA chassis slot.
FortiMail boards are hot swappable. The procedure for removing a FortiMail board from a
chassis slot is the same whether or not the chassis is powered on.
To remove a FortiMail board from a chassis slot
To complete this procedure, you need:
• An ATCA chassis with a FortiMail board installed
• An electrostatic discharge (ESD) preventive wrist strap with connection cord
1 Attach the ESD wrist strap to your wrist and to an available ESD socket or wrist strap
terminal.
2 Disconnect all cables from the FortiMail board, including all network cables, the
console cable, and any USB cables or keys.
Table 3: FortiGate AMC module normal operating LEDs
LED State
HS Off
OOS Off
PWR Amber
OT Off
Tighten
Retention
Screw
Caution: FortiMail boards must be protected from static discharge and physical shock.
Only handle or work with FortiMail boards at a static-free workstation. Always wear a
grounded electrostatic discharge (ESD) preventive wrist strap when handling FortiMail
boards.
Caution: Do not carry the FortiMail board by holding the handles or retention screws.
When inserting or removing the FortiMail board from a chassis slot, handle the board by the
front panel. The handles are not designed for carrying the board. If the handles become
bent or damaged the FortiMail board may not align correctly in the chassis slot.