14 Chapter 1 DaqPRO
6. Choose Display
a. Use the Forward
and Backward arrow buttons to select the type of
display, then press the Enter button
.
In – 1 Current 0-240 mA
In – 2 Thermocouple T
In – 3 Empty
In – 4 Empty
RATE = Every sec
SAMPLES = 10,000
→ DISPLAY = numeric
Note: When you turn the DaqPRO off it will save the setup for the next session.
7. Start Recording
a. After selecting the Display, press the Forward arrow button
to start
recording.
Or
b. Press the Enter button if you want to go back to the first item (Rate).
c. You can stop recording at any time by pressing the Escape button
.
www.esis.com.au
Ph 02 9481 7420
Fax 02 9481 7267
esis.enq@esis.com.au
To Next Page
Loading...