Framery 2Q - Install Bottom, Wall, and Roof Body Covers

Framery 2Q Huddle
15.4 Install the bottom body covers
1. Install the bottom body covers (1 pc each side) in the middle of the floor of the pod.
Push the lower part first under the pod and then guide the flange into the groove on the
wall.
Note: Make sure that the cover has flanged edges.
Tip: Use the small holes in the body covers to center them.
2. Install the bottom body covers (2 pcs each side) on the sides of the floor of the pod.
Guide the edges of the covers on top of the flanges in the middle cover.
170
Installation instructions
info@frameryacoustics.com