Framery 2Q - Attach the Roof Modules Together (Back)

Framery 2Q Huddle
5.2.2 Attach the roof modules together (back)
1. Install M8x55 bolts (5 pcs), M8 washers (5 pcs), and flanged M8 nuts (5 pcs).
2. Install the support plate with steel colored M6x20 screws (4 pcs). Use a hex key to fully
tighten the screws.
Note: Pull the roof modules straight to fit the support plate into place. Use a
hand tool to tighten the screws and bend the roof modules further, if needed.
24
Installation instructions
info@frameryacoustics.com