Framery 2Q Huddle
15.6 Install the roof body covers
1. Install the roof body covers (2 pcs) in the center of the roof.
Installation requires two people: One guides the cover from the ladder, one from the
floor.
Guide the cover first to the center of the roof. Then pull down and guide the lower edge
to the groove on the wall.
2. If you have installed the power cord from the roof, cut the notch out of the body cover.
This is not necessary if you have installed the power cord to the floor module.
Note: You only have to do this when installing for the first time.
174
Installation instructions
info@frameryacoustics.com
To Next Page
Loading...
