Framery 2Q Huddle
7. Install the right-hand side frame with M8x55 bolts (3 pcs) and M8 washers (3 pcs).
8. Tighten the bolts on the upper corner frame of the right-hand side.
8.4 Finalize the installation of the back frames and glasses
1. Tighten the nylon screws (2 pcs each side) on the sides of the back half of the pod with
a flat-head screwdriver.
Note: The nylon screws are only for pushing the glasses together. Tighten the
screws until you feel resistance. Do not overtighten.
Note: Make sure that the back glasses stay aligned and sit snugly in the H-
profile seals when tightening the nylon screws.
Installation instructions
info@frameryacoustics.com
63
To Next Page
Loading...
