Framery 2Q Huddle
3. Press the floor board onto the wooden pins.
Note: Make sure that the narrow end of the floor board is at the open end of
the front half of the floor.
4. Install 5x30 screws (16 pcs).
Note: Do not install screws in the middle of the floor module, where the
doorway is.
Note: Install the screws from the ends of the floor module towards the middle.
Make sure that the pins are in place.
Note: Make sure that the screw heads are level with the floor or deeper.
5. Lay down the front half of the floor.
Installation instructions
info@frameryacoustics.com
35
To Next Page
Loading...
