FRC Turbofoam TFC100 - Controls and Indicators; Button Functions; LED Indicators; Display Information

TFC100 Rev180215
13
Controls and Indicators
All controls and indicators are located on the front of the control module. It contains the push button electronic
controls, LEDs, and digital displays. (Refer to gure.) The buttons are used for operations, reviewing stored data,
and during programming. See Operation and Programming Sections for more information.
ON/OFF Button
Press and hold this button for three seconds to turn the system on. LED goes on. The WATER FLOW display
shows discharge ow rate. A remote ON/OFF switch is available as an option.
PRESET Button
Press this button to set the % foam to a pre-programmed value.
+ / – Buttons
Press the + increase or – decrease buttons to raise or lower the amount of foam concentrate (% foam) that
is mixed into solution. The % display shows the selected percent.
MODE Button (TFC100 Only)
Used to toggle the display mode. A mode LED goes on to indicate the selected display mode. Sets totals to 0.
Mode LEDs (TFC100 Only)
The four LEDs indicate the display mode for the 4-segment display; %FOAM, TOTAL FOAM, FLOW,
and TOTAL WATER.
FOAM EMPTY LED (TFC100 Only)
The input from a TankVision Pro or foam tank level indicator drives this LED.
FOAM % Display
The display shows the selected percent of foam concentrate in the discharge foam solution.
A/B Button (TFC400 Only)
Used to select the A foam or B foam tank. The FOAM A or FOAM B LED goes on for tank selected. When
this button is pressed (with the system is on) a ush cycle automatically occurs before the electric valve switches
the tank (there must be water ow through the discharge).
FLUSH Button (TFC300/400 Only)
Used to operate the ush (or prime) mode. The LED blinks when ush mode is active (there must be water
ow through the discharge).
MENU Button (TFC200/300/400)
Used to access system detailed information, stored data, and program features. Sets totals to 0.
Message Display (TFC200/300/400)
The two line multifunction display shows system information.
When the MENU button is pressed, during calibration, or during programming the display shows codes,
stored data, and program functions.
FLOW Display
The display shows discharge water ow rate through the discharges. In manual mode it shows operator
entered ow rate.