FRC Turbofoam TFC100 - Install Electric ABF Selector; Mounting Location and Connections

TFC100 Rev180215
46
Figure L5. Electric ABF Selector Mounting Dimensions
Install Electric ABF Selector Assembly (TFC400 Only)
Note: The assembly must be mounted lower than the foam tank and higher than the concentrate pump
(the manifold discharge must not be above the foam input connection).
1. Measure and mark location for four (4) mounting holes. Make sure there is clearance for plumbing
connections before drilling holes. Refer to gure for layout and dimensions.
2. Mount with 5/16" hardware.
3. Connect the foam tanks, ush water, and foam pump plumbing. (Refer to Plumbing Connections.)
4. Connect the valve cables and system cable. (Refer to Wiring Section.)
Note: The assembly must be mounted so the manifold
discharge is below the foam input connections.
11"
5 27/32"
3/8"
5 1/2"
4 1/4"
2 3/4"
5 1/8"
1 1/16"
11 3/4"