FRC Turbofoam TFC100 - Wiring Diagrams; Electric Flush Valve Wiring; Manual ABF Selector Wiring

TFC100 Rev180215
63
Figure W5. Manual ABF Selector Wiring
Figure W4. Electric Flush Valve Wiring
Manual ABF Selector TFC200 Only
The TFC200 system is available with an optional selector to make it a dual tank system. Four wires from
the micro-switches located on the manual ABF selector assembly need to be connected.
Two wires are connected to chassis ground, the other two wires are connected to the control module 6-Pin
connector, pin 3 - Select A/B Sensor and 12-Pin connector, pin 6 - Flush/Prime Switch.
6-Pin Valve Connector/Cable
PinWire Description
1/Red Close Valve (+)
2/Black Ground
3/Yellow Close Limit Switch
4/Blue Open Limit Switch
5/Brown Limit Switch Return
6/Green Open Valve (+)
Pins 2 and 5 are jumped
together in the cable harness.
Connect the cable to the foam pump
control 12-Pin Connector pins 5-9.
Closed for
Flush
Manual ABF Selector
Micro-Switches
GND
Closed for
B Foam
Both Opened
for A Foam
Control Module
12-Pin Connector Pin 6
Flush Switch
Control Module
6-Pin Connector Pin 3
Select A/B Sensor
Electric Flush Valve TFC300 (TFC100/200 Option)
This valve is standard on TFC300 models and is available as an option for the TFC100/200 single tank
systems. The valve is controlled by a pushbutton on the TFC300 control module and a separate mounted switch
and indicator for the TFC100/200 option. The valve cable is connected to the foam pump control.
Pin 1