FRC Turbofoam TFC100 - Install Foam Pump Assembly; Pump Assembly Mounting Dimensions

TFC100 Rev180215
43
Install Foam Pump Assembly
Remove and replace the pump oil reservoir red shipping plug with the yellow vented cap/dip stick. Ensure
the oil level is even with the line in the site glass. (The red shipping plug should be saved.)
It is recommended that a minimum of four (4) mounting bolts are installed.
Note: Not all mounting holes are easily accessible on every foam pump assembly. Check specic
model for details.
1. Measure and mark mounting location. Make sure there is clearance for plumbing connections and to
open the calibration valve before drilling holes. (The larger electric motors require 1/2" clearance at
the rear for fan intake.) Refer to gure for dimensions.
2. Mount with 3/8" hardware.
3. Connect the cables to the pump control module. Rout the wiring under the motor to provide a drip loop
to help prevent water from getting to the terminals. (Refer to Wiring Section.)
Figure L2. Foam Pump Assembly Mounting Dimensions
10"
3"
6"
9"
19 1/2"
18 1/2"
5"
1/2"
7"
Through holes on the
mounting plate are clearance
for 3/8" hardware.
Top View
Top View
Typical 1.6, 2.1 and 2.6 GPM
Foam Pump Assembly
Typical 3.5, 5.0, 6.2, 6.5 GPM
Foam Pump Assembly
It is recommended that a minimum of
four (4) mounting bolts are installed.