FRC Turbofoam TFC100 - Optional Remote Control Module Wiring

TFC100 Rev180215
67
12-Pin Connector/Cable
Pin/Wire Description
1/Red Supply Power 12/24 VDC
2/Black Supply Ground
3/Red N/A
4/White N/A
5/Black N/A
6/Red N/A
7/White FRC Datalink (+)
8/Green FRC Datalink (–)
9/Black N/A
10/Red N/A
11 N/A
12 N/A
Optional Remote Control Module
Figure W10. Optional Remote Control Module Wiring
NOTE: For either the TFC100 or TFC200/300/400—
Connect pin 7 and pin 8 to the primary control module
Remote Control Module
TFC200/300/400
Rear View
DC
Power
FRC
Datalink
Cable
FRC
Datalink
Cable
Remote Control Module
TFC100
DC
Power
USB
Access
Port*
USB
Access
Port*
*NOTE: If opened, USB access port plug must be
tightened to a torque of 8-10 in-lbs. Exceeding this torque
value can result in damage to its water seal capability.
Warning: Flange may not fully bottom out.