FRC Turbofoam TFC100 - Set Date and Time; Setting System Date (Code P108); Setting System Time (Code P109)

TFC100 Rev180215
25
Set Date and Time
Note: The TFC100 does not have a message display. Information is only shown in the 4-digit display,
procedures are the same. (Substitute MODE for MENU.)
Set Date (Code P108)
Enter password code 1221. (Refer to Enter Password for Program Access.)
1. Press the + and – buttons and scroll to code P108.
2. Press the PRESET button.
Result: The message display shows the date with the day ashing.
3. Press the + and – buttons to change the day.
4. Press the PRESET button.
Result: The month ashes.
5. Press the + and – buttons to change the month.
6. Press the PRESET button.
Result: The year ashes.
7. Press the + and – buttons to change the year.
8. Press and hold the MENU button for ve (5) seconds to save.
Result: The message display shows DONE.
Set Time (Code P109)
Enter password code 1221. (Refer to Enter Password for Program Access.)
1. Press the + and – buttons and scroll to code P109.
2. Press the PRESET button.
Result: The message display shows the time with the hours ashing.
3. Press the + and – buttons to change hours.
4. Press the PRESET button.
Result: The message display shows time with the minutes ashing.
5. Press the + and – buttons to change the minutes.
6. Press the PRESET button.
Result: The message display shows time with the AM/PM ashing.
7. Press the + and – buttons to change the AM/PM.
8. Press and hold the MENU button for ve (5) seconds to save.
Result: The message display shows DONE.