FRC Turbofoam TFC100 - Fault and Error Code Reports; Incident Code Report

TFC100 Rev180215
17
Fault/Error Code Reports
The fault/error code reports show a list of the most recent fault/error codes in reverse chronological order, and
show a maximum of 20 recorded faults/errors. Once the maximum number of 20 is reached, the system will drop
the oldest fault/error in order to make room for a new fault or error.
S 1
RPM
SEN
OPEN
Flow Display will show "S" and record number
E06
Display shows the descripton for the Fault/Error Code
04:07 PM
08JUN'16
Displays the Time of the incident
Displays the Date of the incident
Display shows the descripton for the Fault/Error Code
NOTE: For each fault/error
code, the Fault/Error Code
Report will cycle through
each screen for approximately
3 seconds.
NOTE: Use the INC and DEC
to navigate through the
fault/error reports.
r 10
FOAM A
[blank]
CLEAR
INCIDENT
CLEAR?
NO
5.3 MINS
3 GALS
Incident Code Report
The report is displayed in reverse chronological order (works just like the error report). Therefore, the rst
incident indicates the total number of recorded incidents. In the example below the number "10" would indicate
that there 10 recorded incidents. The system will hold a maximum of 20 recorded incidents. Once the maximum
number of 20 is reached the system will drop the oldest incident in order to make room for a new incident.
Flow Display will show "r" and current record number
The following lines will cycle (about 3 seconds for each screen) per incident:
Line 1 Displays foam type
Line 2
Line 1
Line 2 Press PRESET.
Display will change to:
Line 1 Displays the Duration
Line 2 Displays the Foam Volume Dispensed
03:11 PM
23MAY’16
Displays the Time of the incident
Displays the Date of the incident
NOTE: Use the INC and DEC to navigate
through the error reports.
PCode 324 (Clears the Incident Report). The following depicts screen shots of this process:
“NO” will ash. Use INC or DEC
to toggle between “NO” and “YES”.
Press and Hold MENU to conrm.
INCIDENT
SECS 60
CLEAR?
NO
Line 1
Line 2
Line 1
Line 2
PCode 325 (Sets the minimum number seconds the pump must run before recorded as an incident. This prevents
short tests from being recorded.)
Press PRESET. Display will ash the least signicant digit and allow the seconds to
be edited. Use the PRESET button to move the ashing eld from one digit to another
and the INC/DEC button to change value. Press and hold MENU to save the setting.
“NO” will ash. Use INC or DEC to change “NO” to “YES”. Press and Hold MENU
to conrm.