Froling P4 - Parameter Settings

Technology
Components, Connections, and Dimensions
Fröling Heizkessel- und Behälterbau Ges.m.b.H, Industriestrasse 12, A-4710 Grieskirchen Page 31
Tel +43 (0) 7248 606-0 Fax +43 (0) 7248 606-600 info@froeling.com www.froeling.com M0930207
3
3.5.5 Wire Connections
R I S K
Working on electrical components.
Danger: Serious injuries from electric shocks.
 Work on electrical components should only be carried out by authorized
technicians.
 Observe the applicable standards and regulations.
 Work must not be carried out on electrical components by unauthorized
persons.
❒ Flexible sheath conductors should be used for the wiring which should be
measured in compliance with the applicable regional standards and
guidelines.
❒ The power supply line (mains connection) must be fitted with a dedicated
15 amp circuit breaker.
❒ Remove the insulating cover.
❒ Remove the two screws and lock washers from the tabs of the controller
cover.
 Caution: Do not lose the lock washers!
❒ Remove the screw and lock washer on the bottom of the controller cover.
❒ Remove the controller cover.