Fronius TPS 600i - Process Parameters for Wire Stick Contact Tip

121
EN
Process parame-
ters for wire stick
contact tip
Select "Process parameters"
Select "Components & Monitoring"
An overview of the process parameters for components and monitoring is displayed:
Select "Wire stick contact tip"
The overview "Wire stick contact tip - setup menu" is displayed.
Turn the adjusting dial and select the desired parameter
Press the adjusting dial (blue background)
Turn the adjusting dial and change the value of the parameter (blue background)
Wire stick on contact tip = ignore:
The wire stick check on the contact tip is deactivated.
Wire stick on contact tip = error (activated):
2
1
1
2
3
3
4
5
6