69
EN
MIG/MAG and CMT welding
Safety
MIG/MAG and
CMT welding –
overview
The "MIG/MAG and CMT welding" section comprises the following steps:
- Switching on the power source
- Selecting the welding process and operating mode
- Selecting the filler metal and shielding gas
- Setting the welding and process parameters
- Setting the shielding gas flow rate
- MIG/MAG or CMT welding
Switching on the
power source
Connect the mains cable
Move the mains switch to the "I" position
A cooling unit connected to the system will begin to operate.
IMPORTANT! For optimum welding results, the manufacturer recommends performing an
R/L alignment when starting the device for the first time and when any changes are made
to the welding system.
More information about the R/L alignment can be found under "R/L alignment" in the "Pro-
cess parameters" section of the "Welding mode" chapter (page 107).
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
WARNING! An electric shock can be fatal. If the power source is connected to the
mains electricity supply during installation, there is a high risk of very serious in-
jury and damage. Before carrying out any work on the device make sure that:
- the power source mains switch is in the "O" position
- the power source is unplugged from the mains
NOTE! If using a cooling unit, follow the safety rules and note the operating con-
ditions in the cooling unit Operating Instructions.
1
2
To Next Page
Loading...
