Fronius TPS 600i - System Components; General; Overview; Options

31
EN
System components
General The power sources can be operated with various system components and options. This
makes it possible to optimise procedures and to simplify machine handling and operation,
as necessitated by the particular field of application in which the power source is to be
used.
Overview
Options
(1) Cooling units also:
- Welding torch
- Grounding (earthing) cable and elec-
trode cable
- Dust filter
- Additional current sockets
(2) Power sources
(2a) TPS 400i LSC ADV power source
(3) Robot accessories
(4) Interconnecting hosepacks
(max. 50 m)*
(5) Wirefeeders
(6) Wirefeeder holder
(7) Trolley and gas cylinder holders
* Interconnecting hosepacks > 50 m only in combination with optional
OPT/i SpeedNet Repeater
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(2a)
OPT/i TPS 2.SpeedNet Connector
Optional second SpeedNet connection socket
Factory-installed on the rear of the power source (but can also be installed on the front of
the power source).
OPT/i TPS 4x Switch SpeedNet
Option if more than one additional SpeedNet connection socket is required.
IMPORTANT! The OPT/i TPS 4x Switch SpeedNet option cannot be operated in conjunc-
tion with the OPT/i TPS 2. SpeedNet Connector option. If the OPT/i TPS 2.SpeedNet
Connector option is installed in the power source, it must be removed.