63
EN
Other tasks Carry out the following steps in accordance with the wirefeeder operating instructions:
Insert the feed rollers into the wirefeeder
Insert the wirespool or basket-type spool with adapter into the wirefeeder
Feed in the wire electrode
Set the contact pressure
Adjust the brake
IMPORTANT! For optimum welding results, the manufacturer recommends performing an
R/L alignment when starting the device for the first time and when any changes are made
to the welding system.More information about the R/L alignment can be found under "R/L
alignment" in the "Process parameters" section of the "Welding mode" chapter“ (page
107).
1
2
3
4
5
To Next Page
Loading...
