80
Job mode
General Up to 1000 jobs can be stored and retrieved in the power source.
This eliminates the need for manual documenting of the welding parameters.
"Job mode" enhances the quality of automated and manual applications.
Jobs can only be stored when in welding mode. When storing jobs, the process parameters
and certain machine defaults are taken into account in addition to the present welding set-
tings.
Storing settings
as a job
Set the parameters that are to be stored as a job:
- Welding parameters
- Welding process
- Process parameters
- Machine defaults (if necessary)
Select "Save as Job"
The job list is displayed.
To overwrite an existing job, select it by turning and pressing the adjusting dial (or selecting
"Next").
The selected job can be overwritten after acknowledging the confirmation prompt.
Select "Create a new Job" to create a new job
Press the adjusting dial / select "Next"
The next free job number is displayed.
Turn the adjusting dial and select the desired storage location
Press the adjusting dial / select "Next"
The keyboard is displayed.
1
2
2
3
4
5
To Next Page
Loading...
