100
Process parameters, General
Process parame-
ters for start of
welding/end of
welding
The following process parameters can be set and displayed for the start and end of weld-
ing:
Starting current
for setting the starting current for MIG/MAG welding (e.g. aluminium welding start-up)
Unit % (of welding current)
Setting range 0 - 200
Factory setting 135
Start arc length correction
For correcting the arc length at the start of welding
Unit % (of welding voltage)
Setting range -10.0 - +10.0
Factory setting 0.0
- shorter arc length
0 neutral arc length
+ longer arc length
Starting current time
for setting the length of time the starting current is to be active
Unit s
Setting range off / 0.1 - 10.0
Factory setting off
Slope 1
for setting the time during which the starting current is decreased or increased to the
welding current
Unit s
Setting range 0.0 - 9.9
Factory setting 1.0
Slope 2
for setting the time during which the welding current is decreased or increased to the final
current.
Unit s
Setting range 0.0 - 9.9
Factory setting 1.0
To Next Page
Loading...
