144
Setting network
parameters man-
ually
Select "Defaults"
Select "System"
Select "Network Setup"
The network setup overview is displayed.
If DHCP is enabled, the IP address, Network mask and Standard gateway network param-
eters are greyed out and cannot be adjusted.
Turn the adjusting dial and select "DHCP"
Press the adjusting dial
DHCP is disabled, the network parameters can now be set.
Turn the adjusting dial and select the desired network parameter
Press the adjusting dial
The numerical pad for the selected parameter is displayed.
Enter a value for the network parameter
Select "OK" and confirm the value for the network parameter / press the adjusting dial
The value for the network parameter is applied, the network setup overview is displayed.
Select "Store" to apply changes to the network setup
3
2
1
1
2
3
4
5
6
7
8
9
10
To Next Page
Loading...
