98
Press the adjusting dial to change the welding parameter
The value of the welding parameter is displayed as a horizontal scale:
The value of the selected parameter can now be changed.
Turn the adjusting dial and change the parameter
Adjust the process parameters accordingly to make user- or application-specific set-
tings on the welding system
Start welding
Welding parame-
ters for manual
metal arc welding
The following welding parameters for MMA welding can be set and displayed by pressing
the "Welding" button:
8
9
9
10
11
Main current
Unit A
Setting range depends on the power source available
Before the start of welding, the device automatically displays a standard value based on
the programmed parameters. During welding, the actual value is displayed.
Starting current
for setting a starting current value in the range 0 - 200% of the set welding current in order
to avoid slag inclusions or incomplete fusion.
The starting current depends on the electrode type.
Unit %
Setting range 0 - 200
Factory setting 150
The starting current is active for the starting current time set under the process parame-
ters.
Dynamic
to influence the short-circuiting dynamic at the instant of droplet transfer
Unit -
Setting range 0 - 100
Factory setting 20
0 Soft, low-spatter arc
100 Harder, more stable arc
To Next Page
Loading...
