Fronius TPS 600i - Process Parameters; Overview - Process Parameters, Common; Overview - Components and Monitoring Process Parameters; Overview - Process Parameters, Job

99
EN
Process parameters
Overview - Pro-
cess parameters,
Common
The "Process parameters" menu button has the following selection options under "Com-
mon":
Overview – com-
ponents and
monitoring pro-
cess parameters
The "Process parameters" menu item has the following selection options under "Compo-
nents & monitoring":
Overview – Pro-
cess parameters,
Job
The "Process parameters" menu button has the following selection options under "Job":
Weld-Start/Weld-End
Process control
TIG/MMA/SMAW Setup
Process mix
Gas-Setup
R/L-check/alignment
Synchropulse
Components
Arc break monitoring
Wire stick workpiece
System calibration
Wire stick contact tip
Wire end monitoring
Optimize Job
Pre-settings for "Save as Job"
Correction limits