Fronius TPS 600i - Connections, Switches and Mechanical Components; TPS 320 I; 400 I; 500 I; 600 I, TPS 400 I LSC ADV Power Source

39
EN
Connections, switches and mechanical components
TPS 320i / 400i /
500i / 600i, TPS
400i LSC ADV
power source
Front Rear
(1)
(2)
(3)
(4)
(6)
(5)
(7)
(8)
(12)
(13)
(9)
(10)
(11)
No. Function
(1) Mains switch
for switching the power source on and off
(2) Control panel cover
for protecting the control panel
(3) Control panel with display
for operating the power source
(4) (-) Current socket with bayonet latch
for:
- connecting the grounding (earthing) cable during MIG/MAG welding
(5) Blanking cover
reserved for the second (+) current socket option with bayonet latch
(6) Blanking cover
reserved for the second SpeedNet connection socket option
(7) Blanking cover
reserved for the second SpeedNet connection socket option
(8) (+) Current socket with fine-pitch thread (Power Connector)
for:
- connecting the current cable from the interconnecting hosepack during MIG/
MAG welding
(9) SpeedNet connection socket
for connecting the interconnecting hosepack
(10) Ethernet port
(11) Mains cable with strain relief device
(12) Blanking cover
reserved for the second (-) current socket option with bayonet latch
The second (-) current socket is for:
- connecting the interconnecting hosepack during MIG/MAG welding for polar-
ity reversal (e.g. for flux-cored wire welding)
(13) Blanking cover
reserved for the second SpeedNet connection socket option or robot interface
RI FB Inside/i