97
EN
** previous page: MIG/MAG pulse synergic, MIG/MAG standard synergic, MIG/MAG
PMC, MIG/MAG LSC, MIG/MAG standard manual, CMT and Job mode
Select the MMA/SMAW welding process
The welding voltage is applied to the welding socket with a three second time lag.
If the MMA/SMAW welding process is selected, any cooling unit present is automatically
deactivated. It is not possible to switch it on.
Select "MMA/SMAW welding"
The MMA welding parameters are shown.
Turn the adjusting dial and select the desired welding parameter
NOTE! Parameters that have been set on a system component control panel
(e.g. wire feed unit or remote control) might not be able to be changed on the pow-
er source control panel.
5
6
**
5
6
7
8
7
To Next Page
Loading...
