143
EN
Example:
Job group 1: Job no. 3 / 4 / 5
Job no. 6 is not assigned ==> End of job group 1
Job group 2: Job no. 7 / 8 / 9
- When welding starts, the job with the lowest number within the job group is automati-
cally selected.
- To change to the job with the next highest number within a job group, press the torch
trigger briefly (< 0.5 seconds).
- To stop welding, press the torch trigger for more than 0.5 seconds.
- To change to the next job group, press the parameter setting button on the JobMaster
welding torch for more than 5 seconds.
Special display for JobMaster = on
The following can now be set and carried out on the JobMaster welding torch:
- Operating mode
- SynchroPulse
- Gas test
Torch trigger job selection = on
This function allows the user to change to the next job using the torch trigger. Job changing
takes place within defined job groups.
A job group is defined by the next non-programmed job.
Example:
Job group 1: Job no. 3 / 4 / 5
Job no. 6 is not assigned ==> End of job group 1
Job group 2: Job no. 7 / 8 / 9
- When welding starts, the job with the lowest number within the job group is automati-
cally selected.
- To change to the job with the next highest number within a job group, press the torch
trigger briefly (< 0.5 seconds).
- To stop welding, press the torch trigger for more than 0.5 seconds.
- To switch to the next job group, press the torch trigger briefly twice
(< 0.3 s, 2 x).
You can switch jobs when the device is in standby or during welding.
> 5 s
To Next Page
Loading...
