196
Cause: The feed rollers are not suitable for the wire electrode being
used
Remedy: Use suitable feed rollers
Cause: Feed rollers have the wrong contact pressure
Remedy: Optimise the contact pressure
Wirefeed problems
when using long hosepacks
Cause: Incorrect arrangement of hosepack
Remedy: Arrange the hosepack in as straight a line as possible, avoid
tight bends
The welding torch becomes very hot
Cause: Welding torch is inadequately dimensioned
Remedy: Observe the duty cycle and loading limits
Cause: Only on water-cooled systems: Inadequate coolant flow
Remedy: Check coolant fill level, coolant flow, for coolant contamination,
etc.
To Next Page
Loading...
