62
Adjusting the brake of the wirespool holders
General D200 wirespool holder:
The brake of the D200 wirespool holder is factory-set to enable optimum braking of full
wirespools with standard steel wire electrodes.
However, in some applications, adjusting the brake can be advantageous. To do so, pro-
ceed as described in section "Adjusting the brake of the D200 wirespool holder".
D100 wirespool holder:
The strength of the braking force on a D100 wirespool is determined by the tightening
torque of the knurled screw on the brake. For more detailed information on adjustment, see
section "Adjusting the brake of the D100 wirespool holder" below.
NOTE! After releasing the torch
trigger (end of welding, end of
wirefeeding), the wirespool must
stop unreeling. If it continues unreeling,
adjust the brake.
To Next Page
Loading...
