66
MIG/MAG standard manual welding
General The MIG/MAG standard manual welding process is a MIG/MAG welding process with no
synergic function.
Changing one parameter does not result in any automatic adjustments to the other param-
eters – all variable parameters must be adjusted individually.
Available parame-
ters
The following parameters are available for MIG/MAG manual welding:
MIG/MAG stand-
ard manual weld-
ing
Press the "Process" button to select MANUAL
Press the "Mode" button to select the desired MIG/MAG mode:
2-step mode
4-step mode
Spot welding/stitch welding
Select and set the wire speed parameter
Select and set the welding voltage parameter
All parameter set values remain stored until the next time they are changed. This applies
even if the power source is switched off and on again.
Ensure that the grounding (earthing) connection has been established
Ensure that the shielding gas supply has been established
- Power source is ready for welding
Corrections dur-
ing welding
The arc-force dynamic parameter can be used to optimise the welding result.
Wire speed
Welding voltage
Arc-force dynamic
For influencing the short-circuiting dynamic at the instant of droplet transfer
Welding current
Only the actual value is displayed
1
2
3
4
5
6
The arc-force dynamic parameter is used to influence the short-circuiting dynamic at the
moment of droplet transfer:
- = hard, stable arc
0 = neutral arc
+ = soft, low-spatter arc
To Next Page
Loading...
