Fronius TransSteel 2200c - Adjusting the Brake of the D200 Wirespool Holder; Adjusting the Brake of the D100 Wirespool Holder

63
EN
Adjusting the
brake of the D200
wirespool holder
Adjust the brake:
4
Adjusting the
brake of the D100
wirespool holder
Adjust the brake:
Tighten the knurled screw (1)
- Knurled screw fully tightened =
high braking force
- Knurled screw slightly tightened =
low braking force
CAUTION! Risk of injury and material damage from an emerging wire electrode
and moving parts due to inadvertent activation of the power source. Before com-
mencing work:
- Turn the power source mains switch to the "O" position
- Disconnect the power source from the mains
- Ensure that the power source remains disconnected from the mains until all
work has been completed
1
2
1
CAUTION! Risk of injury and material damage from an emerging wire electrode
and moving parts due to inadvertent activation of the power source. Before com-
mencing work:
- Turn the power source mains switch to the "O" position
- Disconnect the power source from the mains
- Ensure that the power source remains disconnected from the mains until all
work has been completed
(1)
1