119
EN
Welding parame-
ters in the cold
wire setup
"Minimum" and "maximum" are used for setting ranges that differ according to power
source, cold wire-feed unit, welding program, etc.
Wirefeed spd2
Wire feed speed 2
Unit % (of the wire feed speed)
Setting range 0 - 100
Factory setting 50
If a value is set for both 'wire feed speed 2' and 'pulse frequency', then the wire feed speed
alternates between the following values in sync with the pulse frequency of the welding
current:
- Wire feed speed from the TIG welding parameters
- Wire feed speed 2
Start-delay
Delay in the start of wirefeeding from beginning of the main current phase
Unit s
Setting range OFF / 0.1 - 9.9
Factory setting OFF
End-delay
Delay in the start of wirefeeding from end of the main current phase
Unit s
Setting range OFF / 0.1 - 9.9
Factory setting OFF
Wire threading
Wire threading speed
Unit m/min ipm.
Setting range 0.1 - max. 3.94 - max.
Factory setting 5 197
Wire wdraw
Unit mm in.
Setting range OFF / 1 - 50 OFF / 0.04 - 1.97
Factory setting OFF OFF
IMPORTANT!Wire withdrawal prevents the welding wire from burning at the end. Before
the welding current is switched off, the wire is withdrawn to the set value. A prerequisite
for this function is that the arc has ignited.
Push-pull
Selecting and calibrating the push-pull unit
Unit -
Setting range 00 - KD7000/VR1530KD22m
01 - KD7000/VR1530KD30m
02 - RobactaKD-Drive 10m
03 - RobactaKD-Drive 220m
15 - KD7000/VR1530KD10m
18 - RobactaKD-Drive 5m
19 - KD4010 10m
21 - BinzelTorchDr.IWG 8m
25 - KD7000-VR1530KD10m
Factory setting 0
To Next Page
Loading...
Need help?
General
