53
EN
TIG welding
Safety
Welding parame-
ters: display and
navigation
The TIG welding parameters are shown as soon as the 2-step or 4-step mode is selected.
Use the left and right arrow keys to navigate within the welding parameters.
Welding parame-
ters for TIG
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
WARNING! An electric shock can be fatal. If the power source is connected to the
mains electricity supply during installation, there is a high risk of very serious in-
jury and damage. Before carrying out any work on the device make sure that:
- the power source mains switch is in the "O" position
- the power source is unplugged from the mains
Starting current 2-step mode Starting current 4-step mode
Unit % (of main current)
Setting range 30 - 200 AC, 0 - 200 DC
Factory setting 35 AC, 50 DC
IMPORTANT! The starting current is saved separately for the TIG AC welding and TIG
DC welding modes.
To Next Page
Loading...
