48
2-step mode - Welding: Pull back and hold the torch trigger
- End of welding: Release the torch trigger
Spot welding If a value has been set for the SPt set-up parameter, 2-step mode will have the spot weld-
ing mode function. The special spot welding indicator on the control panel will light up.
- Welding: briefly pull back the torch trigger
The welding time corresponds to the value set for the SPt set-up parameter.
- to end the welding process prematurely: pull the torch trigger back again
When using a pedal remote control, the spot welding time starts when the pedal remote
control is operated. The power cannot be controlled using the pedal remote control.
Spot welding
NOTE! To work in 2-step mode after it has been selected, the SPt set-up param-
eter must be set to "OFF" and the spot welding indicator on the control panel must
not light up.
2-step mode
... Manual application ... Automatic application
I
t
I
1
G-L / G-HGPr t
up
t
down
I
S
GPr t
E
I
E
t
S
G-L
G-H
I
t
I
1
GPr t
up
t
down
SPt
G-L
G-H
I
S
t
E
I
E
t
S
To Next Page
Loading...
Need help?
General
