Fronius TransTig 2200 Comfort - TIG Setup 2 Nd; Opening the TIG Setup 2 Nd; Changing Welding Parameters

97
EN
TIG setup 2nd
Opening the TIG
setup 2nd
Changing weld-
ing parameters
Opening the TIG setup
Select the 'TIG setup 2nd' parameter
Press the adjusting dial
The TIG setup 2nd parameters are shown:
The power source is now in TIG setup 2nd
1
2
3
Select the desired welding parameter by turning the adjusting dial:
To set the welding parameter, press the adjusting dial
The value of the selected welding parameter can now be changed:
1
2